Range hood not pulling smoke? Fan roaring, lights out or controls dead? Super Appliance Repair fixes range hoods and vent hoods, from wall and island chimneys to inserts and downdrafts, in kitchens across Seattle, Bellevue and the surrounding Eastside cities.
.jpg)
Most range hood failures come down to the blower, the controls or the airflow path. Here is what we see most often in Seattle-area kitchens, and what is usually behind each symptom.
Grease-clogged filters, a damper stuck closed, a crushed or undersized duct, or a blower motor that has lost speed.
A failed blower motor or capacitor, a bad speed switch or control board, or a tripped breaker or thermal fuse.
A failed speed switch, a worn touch control or a relay on the control board that has stuck closed.
A loose or unbalanced blower wheel, worn motor bearings, a fluttering backdraft damper or grease buildup on the fan blades.
A burned-out bulb or LED module, a failed light switch, a bad transformer or driver, or a control board fault.
Grease or moisture behind the control panel, a failed touch board, a loose ribbon cable or a dead remote receiver.
Saturated filters, a clogged grease channel, or condensation running back down a duct that isn't sloped or insulated properly.
A failed lift motor, a broken gear or linkage, a bad limit switch or a control fault on a pop-up downdraft vent.
A heat-sensing auto-on feature reacting to a hot cooktop, a failing temperature sensor or a control board fault.
A wall chimney, a ceiling-hung island hood and a pop-up downdraft are built very differently. Our technicians carry the meters and manufacturer service data to diagnose all of them, whether the hood is ducted outside or recirculating.
Chimney and under-cabinet hoods over ranges and cooktops, including high-CFM pro hoods over gas rangetops.
Ceiling-hung hoods over kitchen islands, where long duct runs and open sides make airflow problems more common.
Custom hood inserts and power packs hidden inside wood or plaster hoods, plus inline and remote blowers mounted in the attic or on the roof.
Pop-up downdraft vents behind cooktops and built-in downdraft systems from brands like JennAir, Thermador and Gaggenau, including the lift and blower.
Weak suction is the most common range hood complaint, and it isn't always the motor. These three things cause most of it.
Clogged filters. Mesh and baffle filters choke airflow as they load up with grease. Clean them as often as your hood's manual recommends, or more if you cook a lot.
A stuck damper or blocked duct. The backdraft flap at the hood or at the wall or roof cap can stick shut, and ducts can get crushed or coated with grease.
A tired blower. If the filters and duct are clear and the fan still sounds weak, the motor, capacitor or blower wheel usually needs repair.

No guesswork and no surprise charges. Every visit follows the same four steps.
Tell us the brand, model and what the hood is doing. The model label is usually inside the hood, behind the grease filters.
Your technician checks the blower, motor, capacitor, controls and lights, plus the damper and duct path, then explains the problem and gives you the repair price before any work starts.
If the part is on hand, we fix it on the first visit. Brand-specific parts for hoods from Wolf, Thermador or Zephyr are ordered and installed on a follow-up visit.
We run the fan through every speed, confirm the damper opens and the hood is capturing smoke and steam, and make sure it runs quietly before we leave.
We repair range hoods and vent hoods from every major manufacturer, including Zephyr, Broan, Best and Vent-A-Hood, with extra depth on the pro-style brands common in Seattle and Eastside kitchens. Pick your brand to learn more.
Most range hood problems are worth fixing. Motors, capacitors, switches, lights and control boards cost far less than a new hood, and a custom insert or a hood matched to your range and cabinetry is rarely easy to swap. After the diagnosis, we tell you plainly which option makes sense.

Our technicians work out of Seattle and Bellevue, so most of King and south Snohomish County is a short drive away. Choose your area to see local details, or browse our full service area.
Check availability: (510) 612-5706Don't see your question? Call us at (510) 612-5706 and a technician will help.
It depends on the fault and the part. A light module, switch or capacitor costs much less than a blower motor or control board. Your technician diagnoses the hood first and gives you the full repair price before starting any work.
The usual causes are grease-clogged filters, a damper stuck closed, a blocked or crushed duct, or a weak blower motor. If cleaning the filters doesn't help, the damper, duct or motor needs a closer look.
A loud hood usually has a loose or unbalanced blower wheel, worn motor bearings, grease on the fan or a fluttering damper. Some noise on high speed is normal, but rattling, grinding or a new roar is not.
Yes. Vent hood, range hood, exhaust hood and kitchen hood all describe the same appliance. Ducted hoods vent outside, while recirculating hoods pass the air through charcoal filters and return it to the kitchen. We repair both.
Yes. Cooktops and pro rangetops are covered by our cooktop repair service, and freestanding or slide-in ranges by our stove and range repair page.
We repair range hoods in Seattle, Bellevue, Kirkland, Redmond, Bothell, Shoreline, Mill Creek, Everett and nearby communities. See our service area page for the full list.
Call or book online and a Super Appliance Repair technician will diagnose your wall, island, insert or downdraft range hood in your kitchen.