Freezer not freezing? Frost building up, food going soft or the compressor running nonstop? Super Appliance Repair fixes upright, chest, drawer and built-in freezers in homes across Seattle, Bellevue and the surrounding Eastside cities.


A warm freezer is a race against the clock. These USDA food-safety guidelines help you save what you can until your technician arrives.
Keep the door closed. A full freezer holds a safe temperature for about 48 hours, a half-full one for about 24 hours.
Group packages tightly together so they keep each other cold, and put an appliance thermometer inside to track the real temperature.
Food that still has ice crystals or is at 40°F or below can be refrozen. When in doubt, throw it out.
Most freezer failures come down to airflow, the defrost system or the parts that start the compressor. Here is what we see most often in Seattle-area homes, and what is usually behind each symptom.
A failed evaporator fan, iced-over coils from a defrost fault, dirty condenser coils or a start relay that won't let the compressor run.
A torn door gasket, a door that doesn't close fully, or a failed defrost heater, defrost thermostat or timer.
The freezer is running a few degrees warm, usually from a weak fan, dirty coils, a failing thermostat or an early sealed-system problem.
Dirty condenser coils, a failed condenser fan, a leaking door seal or low refrigerant keeping the compressor working nonstop.
A clogged or frozen defrost drain, a cracked drain pan, or meltwater from heavy frost that built up behind a bad seal.
A worn evaporator or condenser fan motor, a start relay clicking on and off, or a loose drain pan vibrating against the cabinet.
A failed start relay or overload, a bad control board, a tripped GFCI outlet or a compressor that won't start.
Most chest freezers have no fans, so the cause is usually the thermostat, the start relay, the lid seal or the sealed system itself.
A warm-temperature alarm after the door was left open, a failed sensor or a control board fault on built-in and digital models.
A frost-free upright, a manual-defrost chest freezer and a built-in column each fail in their own way. Our technicians carry the meters, thermometers and manufacturer service data to diagnose all of them.
Frost-free and manual-defrost upright freezers in garages, basements and kitchens, including garage-ready models.
Manual-defrost chest freezers, where cooling lines run through the walls, so diagnosis centers on the thermostat, relay and sealed system.
Bottom-mount freezer drawers in French door models and undercounter freezer drawers, where slides, seals and airflow all matter.
Column and panel-ready freezers from Sub-Zero, Thermador, Liebherr, Miele and Fisher & Paykel, where access and part fit take model-specific know-how.

No guesswork and no surprise charges. Every visit follows the same four steps.
Tell us the brand, model and what the freezer is doing. The model number is usually on a label inside the door, on an inside wall or on the back of the unit.
Your technician checks temperatures, fans, the defrost system, door seals and the compressor start circuit, then explains the problem and gives you the repair price before any work starts.
If the part is on hand, we fix it on the first visit. Brand-specific parts for models like Sub-Zero, Thermador or Miele are ordered and installed on a follow-up visit.
We confirm the fans and defrost system are working, check the door seal and make sure the freezer is pulling down toward 0°F before we leave.
We repair freezers from every major manufacturer, from everyday upright and chest models to the built-in columns common in Seattle and Eastside kitchens. Pick your brand to learn more.
Most freezer problems are worth fixing. Fans, defrost parts, thermostats and start relays cost far less than a new freezer, and a built-in column is almost always worth repairing. The main exception is a failed compressor or refrigerant leak on an older budget model. After the diagnosis, we tell you plainly which option makes sense.

Our technicians work out of Seattle and Bellevue, so most of King and south Snohomish County is a short drive away. Choose your area to see local details, or browse our full service area.
Check availability: (510) 612-5706Don't see your question? Call us at (510) 612-5706 and a technician will help.
It depends on the fault and the part. A start relay, thermostat or fan motor costs much less than a compressor or sealed-system repair. Your technician diagnoses the freezer first and gives you the full repair price before starting any work.
The most common causes are a failed evaporator fan, a defrost fault that let the coils ice over, dirty condenser coils or a bad start relay. If the freezer runs but stays warm, call before the food starts to thaw.
Frost usually means humid air is getting in through a torn gasket or a door that doesn't seal, or that the defrost heater, defrost thermostat or timer has failed. Heavy frost eventually blocks airflow and stops the freezer from cooling.
According to the USDA, a full freezer holds a safe temperature for about 48 hours and a half-full one for about 24 hours, as long as the door stays closed. Food that still has ice crystals or is at 40°F or below can be safely refrozen.
If the fresh-food section is warm too, it's usually a refrigerator cooling problem covered by our refrigerator repair service. If the freezer is cold and only the ice has stopped, see our ice maker repair page.
We repair freezers in Seattle, Bellevue, Kirkland, Redmond, Bothell, Shoreline, Mill Creek, Everett and nearby communities. See our service area page for the full list.
Call or book online and a Super Appliance Repair technician will diagnose your upright, chest, drawer or built-in freezer in your home.